SEN P-8000 Pond Water Pump: 8000 GPH

Description

SEN P-8000 Pond Water Pump, 8000 GPH
Vortex Impeller
Multi-use (submersible or in-line)
Powerful, Quiet, Reliable
Thermally protected
Special ceramic shaft
Silent operation
Practical Handle
Maintenance free
High Performance
Ideal for Pond & Freshwater.
Trouble Free
Cord Length 20 feet
Power: 640 Watt
Max Head: 30 feet
Max Flow: 8000 GPH
Size:
15 3/4"x 9 3/4"x 8 3/4"
Inlet: 2"
Outlet: 1.5"
Weight: 27#
Application
Outdoor Falls (8000 gallon)
Pond
Hydroponics
Fountains
Aquarium
Water movement
Safety Instruction:
Make sure that your electrical voltage is the same voltage as mentioned on the label of the pump.
To avoid the possibility of the plug and the receptacle to get wet, creating a drip loop will help prevent water travel along the cord to the receptacle and plug.
Use pump with water only.  Do not use Gasoline or Solvent that is flammable or explosive fluids.
Do not run pump without water.  Even if the pump is running continuously, permanent damages could occur.
Do not operate pump if it is damaged or malfunctioned cord or plug.
Do not operate pump if it is dropped or damaged in any matter.
Always unplug the pump from the outlet when not in use before putting on or taking off parts and before cleaning.  Never yank the cord to pull it from the outlet.  Grasp the plug and pull to disconnect.
Securely install the pump before operating.
Do not expose the appliance to weather of temperatures below freezing.
Only use a proper rating extension cord when needed.  a cord rated for less amperes of watts than the pump rating may overheat. *** Arrange cords so they will not be tripped or pulled out of socket accidentally.
Do not attempt to repair pump yourself.  Return the pump to the authorize service center for service or discarding of the pump.
Always us a properly grounded receptacle.
Maintenance (impeller):
Disconnect the plug before performing maintenance.
Gently take off the impeller housing form the pump motor unit
Pull out the complete magnetic impeller set from the motor unit
Clean and wipe complete magnetic impeller set to remove accumulated dirt, debris and deposits.  Only rinse with running water. *** Do not use sop or cleaning agents.  Do not take the impeller apart.  It is not designed to be taken apart.  If the magnetic impeller set does not work properly, the complete magnetic impeller set will be replaced.
Re-install the complete impeller set onto shaft, impeller housing