3D Printed Maxspect Gyre Anemone Guard 280 330 350 NEM PETG XF280 XF330 XF350 XF

Description

Up for sale is a brand new PETG Maxspect Gyre Anemone guard. Printed in PETG filament to be completely reef safe. These simply slide over the original cages and snap into place. Tight tolerances inside keep the guard on snugly. The guards are printed with a gap between our guard holes and the original cage slots to allow for more surface area and to help prevent a vacuum. This covers the intake side to keep small fish, anemones and other animals from the impeller. Each guard contains an area without holes that is designed to match with the original cage.
On the 330 and 350 series pumps, you will need to remove the rubber end cap prior to installing our guard. This was done due to the rubber caps being a larger diameter than the actual cage. The rubber cap can be installed again after sliding the anemone guard on.
**Each order is for 2 anemone guards, enough to cover 1 pump. 1 guard for each cage/side of the pump.**
Bare in mind that any guard will reduce flow rate some, and pump may need turned up to produce desired rates after install.
These are printed to order, so please allow a little extra time for this. We will be adding more colors as we can get time to print them. Custom colors are available, feel free to shoot me a message with what you'd like.
If you are unhappy with the product after receiving it, returns are accepted. Please note that this is a 3D printed item, and may show layer lines or slight imperfection due to the nature of the printing process.
Shipping in the U.S. ONLY for now.
*Please note that no pumps are included in this listing. This listing is for the plastic guard ONLY!*